CDF 16
BOGE CDF 16 compressed air station air cooled with frequency control and integral refrigerant compressed air
dryer
Complete and ready to connect, fully automatic operation, with CE approval stamp
- Ducted cooling air by means of sound insulation hood lined with dirt repellent material; integrated electrical control panel (to IP 54)
- with supply air filter fitted at cooling air inlet
- Compressor unit isolated from mechanical vibration
- Patented BOGE GM drive system constant belt tension, maintenance free.
- Hermetically sealed BOGE suction regulator ensures no load starting and safe operation of all moving parts
- Minimal pressure loss with BOGE oil injected air end with optimised screw profile mounted directly on to the receiver.
- Constant low oil carry-over in all operating phases due to efficient pre-separation in horizontal compressed air-oil separator vessel
- Easy maintenance due to spin-on oil separator cartridge and high capacity oil filter; valveless oil circuit
- No condensate in the oil due to thermostatically controlled oil cooler
- Low compressed air outlet temperature due to high efficiency after cooler
- Powder coated surface, light blue, RAL 5012
- Economical operating mode selection due to BOGE control, regulation and monitoring systems with micro processor control and individual fault message displays
- Constant compression temperature and pressure display
- Precise pressure adjustment via keypad
- Anti-freeze protection for compressors up to -10°C
- Compressed air supply to demand due to variable control of motor and compressor speed
- Suitable for fluctuating compressed air demands, installations with small compressed air receivers and as the peak load compressor in a multiple compressor installation.
- Separate systems for electrical frequency and compressor control.
- Very low electrical start-up power requirement
- The system complies with EMC directives for use in industrial areas
- Constant network pressure.
- Soft start-up and run-down in a matter of seconds.
- BOGE refrigerant compressed air dryer for automatic operation and ready for connection and operation
- Energy-saving, compact design refrigerant compressed air dryer
- Hermetically sealed refrigerant compressor, maintenance free
- Constant pressure dew point maintained in each operating phase from 0 - 100 % flow rate
- Manifold complete with all necessary receiver fittings like type tested safety valve, pressure gauge, relief valve with threaded test point stop valve at the compressed air outlet, condensate manual drain valve
- Minimum quantity of ozone friendly refrigerant
- Instrument panel
- ON/OFF-switch with indicator lamp
- thermometer to display pressure dew point
- High level of protection against corrosion by using fully-galvanised and coated panels
- Power supply cable with plug ( 230 V AC only )
- External, electronic, level controlled condensate drain
Bekomat
operates economically with no loss of compressed air
- Bypass permits operation without the refrigerant compressed air dryer
